Saturday 24 October 2015

OBD1READ module :: NEW ORDERING OPTIONS


  New ordering options are available!

!! AS OF 2015/05/23 PLEASE NOTE THE STANDARD VERSION IS DISCONTINUED !!

You can now order your OBD1READ device with 3 wire ends type. the Standard version with the probes and shrink wrap sleeves, the Bare version with nothing but bare wire ends and the 22pin version.

Standard OBD1READ and Bare OBD1READ shown together

  All variants have their intended uses.  

Standard version pricing follows the existing Price Table.

The standard version is meant for all use cases and all supported engine/cars variants, supporting all diagnosis box types while still retaining an affordable price.

Bare version comes with a price reduction of 1,50$ USD over Standard pricing

The Bare version is meant for use in hard wired installs (directly tapping into the engine harness near the ECU.It can  happen if you want the best Bluetooth signal strength from inside your car,or you have a custom engine swap that do not respect anymore the wiring diagram )

22 Pin plug & play version adds 5$ USD over Standard pricing

Pricier, the 22 pin version can connect directly into both 17 pins and 22 pins diagnosis boxes, this alleviates any connection errors or loose connection problems. Easiest and fastest to setup for temporary use on various cars and most robust connection for a permanent plug & play install.
22 pin connector variant, you can't mess up wire connection with this one!

5 comments:

  1. Replies
    1. contact me at jfrancoisbreton at hotmail dot com

      Delete
    2. Where can I buy this device.

      Delete
    3. Not available anymore. was found on www.zf-scantools.com
      please register there if you want to be e-mailed on the launch of the replacement tool; the TOYOCOM.

      Delete